Rokonet ORBiT-14 Instrukcja Użytkownika Pobierz pdf (Strona 48)

Installation and Programming Manual

2) Zones

The following parameters are used for programming the characteristics of each of the system’s protective zones.

With the display showing:

press [ENTER] to begin. The first sub-category, ONE BY ONE,

Quick Key Item Default Explanation

permits the sequential programming of the set of a Zone’s

Parameters, which include its: Partition Assignment, Type, Sound,

Termination, Loop Response, and Label

§ to program the full complement of parameters for each zone–on a

§ one-by-one basis–follow these steps:

from this display, press

[ENTER]

a) specify the two-digit Zone Number from which you wish to start your

programming (e.g. 01)

b) press [ENTER] again to access the category on

Partition Assignments

§ the “xx” in the Z=xx designation refers the number of the zone

currently eligible for a partition assignment(s)

§ use the [STAY] key to toggle between YES (Y) or NO (N), as to

whether the currently-selected zone is to be assigned to the

designated partition

§ a system “without” partitions is regarded as having a single partition

(i.e. Partition 1)

§ use either the [STAT] or [BYP] keys to move the cursor left or right,

respectively

§ keep in mind that in a multi-partitioned system, a zone may be

assigned to more than one partition.

§ when done, press [ENTER] to proceed to the next category–Zone

Types for instructions on programming Zone Types, as well as the

remaining four zone categories, refer to the following pages:

For Zone Types:

For Zone Sounds:

For

Zone Terminations:

For Loop Response:

For Zone Labeling:

page 50

page 53

page 54

page 56

ONE-BY-ONE

includes programming

for each of the following

zone parameters:

§ Partitions

§ Zone Type

§ Zone Sound

§ Zone Termination

§ Zone Response

§ Zone Label

INSTALLER PROG:

2)ZONES ×

SUBJECT: ZONES

1)ONE BY ONE ↓

SUBJECT: ZONES

1)ONE BY ONE ↓↓

P=12345678 Z=xx

Y.......

INSTALLER PROG:

2)ZONES ↓↓

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 69 70

Komentarze do niniejszej Instrukcji

Brak uwag

Rokonet ORBiT-14 Instrukcja Użytkownika Strona 48

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Rokonet ORBiT-14